Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Extreme Networks EAS 100-24t Switch Software Manual
159
CHAPTER
7
Monitoring
Cable Diagnostics
This window displays the details of copper cables attached to specific ports on the Switch. If there is an
error in the cable this feature can determine the type of error and the position where the error has
occurred.
To view this window, click Monitoring > Cable Diagnostics:
Enter the range of ports to test and click Tes t. The results will be displayed in the table on the lower
half of the window.
NOTE
If the Link Status field for an interface displays "Link Up", the value displayed in the Cable Length field
may not be accurate for the interface
CPU Utilization
This window displays the percentage of the CPU being used, expressed as an integer percentage and
calculated as a simple average by time interval.