Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Chapter 6: Access Control List (ACL)
Extreme Networks EAS 100-24t Switch Software Manual
156
To search for an entry, select the profile ID from the drop-down menu, enter a port to view, and click
Find, the table on the lower half of the window will display the entries. To delete an entry click the
corresponding Delete button.
ACL Flow Meter
This window offers flow bandwidth control used to limit the bandwidth of the ingress traffic. When
users create an ACL rule to filter packets, a metering rule can be created to associate with this ACL rule
to limit traffic. Due to limited metering rules, not all ACL rules can associate with a metering rule.
To open this window, click ACL > ACL Flow Meter
In this window, the following parameters can be configured:
Enter the appropriate information and click Find. The entries will be displayed on the lower half of the
table. To edit an entry, click the corresponding Modify button. To delete an entry, click the
corresponding Delete button. To add a new entry, click the Add button, which will display the
following window for the user to configure:
In this window, the following parameters can be configured:
Parameters Description
Profile ID The pre-configured Profile ID for which to configure the Flow Metering
parameters.
Access ID (1-65535) The pre-configured Access ID for which to configure the Flow Metering
parameters.
Parameters Description
Profile ID Use the drop-down menu to select the pre-configured Profile ID that will be
used to configure the Flow Metering parameters.
Access ID (1-65535) Enter the Access ID that will be used to configure the Flow Metering
parameters, enter a value between 1 and 65535.