Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Chapter 6: Access Control List (ACL)
Extreme Networks EAS 100-24t Switch Software Manual
150
To return to the Access Profile List window, click Show All Profiles. To add a rule to a previously
configured entry, click on the corresponding Add/View Rules button and then click Add Rule on the
Access Rule List window, which will reveal the following window:
In this window, the following parameters can be configured:
Parameters Description
Access ID (1-65535) Type in a unique identifier number for this access. This value can be set from
1 to 65535.
Auto Assign – Ticking this check box will instruct the Switch to automatically
assign an Access ID for the rule being created.
Class Entering a class will instruct the Switch to examine the class field of the IPv6
header. This class field is a part of the packet header that is similar to the
Type of Service (ToS) or Precedence bits field in IPv4.
Flow Label Specifies the IPv6 Flow Label. Enter a value between 0 – FFFFF.
IPv6 Source Address Specifies an IPv6 address for the IPv6 source address.
IPv6 Source Mask Specifies an IPv6 source submask.
TCP Source Port - Specifies an IPv6 L4 TCP source port submask.
Destination Port - Specifies an IPv6 L4 TCP destination port submask.
UDP Source Port - Specifies an IPv6 L4 UDP source port submask.
Destination Port - Specifies an IPv6 L4 UDP destination port submask.