Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Access Profile List
Extreme Networks EAS 100-24t Switch Software Manual
145
To return to the Access Profile List window, click Show All Profiles. To add a rule to a previously
configured entry, click on the corresponding Add/View Rules button, and then click Add Rule on the
Access Rule List window, which will reveal the following window:
In this window, the following parameters can be configured:
Parameters Description
Access ID (1-65535) Type in a unique identifier number for this access. This value can be set from
1 to 65535.
VLAN Name Specifies a VLAN name.
VLAN ID (1-4094) Mask ____ (0-FFF) – Specifies a VLAN ID.
Source IP Address Specifies an IP address for the source IP address.
Source IP Mask Specifies an IP address mask for the source IP address.
Destination IP Address Specifies an IP address for the destination IP address.
Destination IP Mask Specifies a destination IP address mask for the destination IP address.
DSCP Selecting this option instructs the Switch to examine the DiffServ Code part of
each packet header and use this as the criteria, or part of the criterion for
forwarding.
ICMP Select ICMP to instruct the Switch to examine the Internet Control Message
Protocol (ICMP) field in each frame's header.
ICMP Type - Specifies that the Switch will examine each frame’s ICMP Type
field.
ICMP Code - Specifies that the Switch will examine each frame’s ICMP Code
field.