Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Chapter 6: Access Control List (ACL)
Extreme Networks EAS 100-24t Switch Software Manual
142
To view the configurations for previously configured rules, click on the corresponding Show Details
button, which will display the following Access Rule Detail Information window:
Access Profile List – IPv4 ACL
To create an IPv4 ACL, click Add ACL Profile in the Access Profile List window and then use the
drop-down menu to select a Profile ID between 1 and 256, click the IPv4 ACL radio button, and then
use the drop-down menu to select a protocol ICMP, IGMP, TCP, UDP, or Protocol ID. Click Select and the
following window will appear (this window will vary depending on whether ICMP, IGMP, TCP, UDP,
or Protocol ID has been selected):
Click on the boxes near the top of the window, which will then turn red and reveal parameters for
configuration. To create a new entry, enter the appropriate information and click Create. To return to the
Access Profile List window, click <<Back.