Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List

Access Profile List
Extreme Networks EAS 100-24t Switch Software Manual
141
Click Apply to display the following Access Rule List window:
Action Select Permit to specify that the packets that match the access profile are
forwarded by the Switch, according to any additional rule added (see below).
Select Deny to specify the packets that match the access profile are not
forwarded by the Switch and will be filtered.
Select Mirror to specify that packets that match the access profile are mirrored
to a port defined in the config mirror port command. Port Mirroring must be
enabled and a target port must be set.
Priority (0-7) Enter a priority value if you want to re-write the 802.1p user priority of a
packet to the value entered in the Priority field, which meets the criteria
specified previously in this command, before forwarding it on to the specified
CoS queue.
For more information on priority queues, CoS queues and mapping for 802.1p,
see the QoS section of this manual.
Replace Priority Click on the box to enable this option and manually enter the replacement
value used to re-write the 802.1p user priority value entered in the Priority
field, which meets the criteria specified previously in this command, before
forwarding it on to the specified CoS queue. Otherwise, a packet will have its
incoming 802.1p user priority re-written to its original value before being
forwarded by the Switch.
Replace DSCP (0-63) Select this option to instruct the Switch to replace the DSCP value (in a
packet that meets the selected criteria) with the value entered in the adjacent
field.
Counter Specifies whether counter feature will be enabled or disabled.
This is optional, the default is disabled.
Ports Enter a range of ports to be configured.
Parameters Description