Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Chapter 5: Security
Extreme Networks EAS 100-24t Switch Software Manual
132
Click on the Apply button to accept the changes made.
Click on the Apply button to accept the changes made.
MAC-based Access Control Local Settings
The following window is used to set a list of MAC addresses, along with their corresponding target
VLAN, which will be authenticated for the Switch. Once a queried MAC address is matched in this
table, it will be placed in the VLAN associated with it here. The switch administrator may enter up to
128 MAC addresses to be authenticated using the local method configured here.
To enable the MAC-based Access Control Local MAC Settings on the switch, click Security > MAC-
based Access Control > MAC-based Access Control Local Settings:
Click on the Add button to add a new entry.
Click on the Delete By MAC button to delete an entry based on the MAC address entered.
Click on the Delete By VLAN button to delete an entry based on the VLAN name or ID entered.
Click on the Find By MAC button to find an entry based on the MAC address entered.
Click on the Find By VLAN button to find an entry based on the VLAN name or ID entered.
Click on the View All button to view all the available entries on this Switch.
Authorization Network When enabled, authorized attributes (for example VLAN) assigned by the
RADUIS server or local database. Which attributes will be accepted depends
on the individual module’s setting.
Authorization for attributes is disabled by default.
Parameters Description
Port Settings
From Port/To Port Enter the Port range.
State Use the pull-down menu to enable or disable the MAC-based Access Control
function on individual ports.
Aging Time (1-1440) Enter an aging value between 1 and 1440 minutes. The default is 1440. Tick
the Infinite check box for no aging time.
Hold Time (1-300) Enter a hold value between 1 and 300 seconds. The default is 300. Tick the
Infinite check box for no hold time.
Max User (1-128) Enter a value for the maximum number of users, between 1 and 128. The
default is 128. Tick the No Limit check box for no maximum user limit.
Parameters Description