Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Access Authentication Control Folder
Extreme Networks EAS 100-24t Switch Software Manual
129
To view the following table, click Security > Access Authentication Control > Enable Method Lists:
To delete an Enable Method List defined by the user, click the the Delete button. To modify an Enable
Method List, click on its corresponding Edit button.
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
Local Enable Password Settings
This window will configure the locally enabled password for the enable admin command. When a user
chooses the "local_enable" method to promote user level privileges to administrator privileges, he or she
will be prompted to enter the password configured here that is locally set on the Switch.
Parameters Description
Method List Name Enter a method list name defined by the user of up to 15 characters.
Priority 1, 2, 3, 4 The user may add one, or a combination of up to four of the following
authentication methods to this method list:
local_enable - Adding this parameter will require the user to be authenticated
using the local enable password database on the Switch. The user in the next
section entitled Local Enable Password must set the local enable password.
none - Adding this parameter will require no authentication to access the
Switch.
radius - Adding this parameter will require the user to be authenticated using
the RADIUS protocol from a remote RADIUS server.
tacacs - Adding this parameter will require the user to be authenticated using
the TACACS protocol from a remote TACACS server.
xtacacs - Adding this parameter will require the user to be authenticated using
the XTACACS protocol from a remote XTACACS server.
tacacs+ - Adding this parameter will require the user to be authenticated using
the TACACS protocol from a remote TACACS server.
server_group - Adding a previously configured server group will require the
user to be authenticated using a user-defined server group previously
configured on the Switch.