Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Chapter 5: Security
Extreme Networks EAS 100-24t Switch Software Manual
126
Switch. More than one authentication protocol can be run on the same physical server host but,
remember that TACACS/XTACACS/TACACS+/RADIUS are separate entities and are not compatible
with each other. The maximum supported number of server hosts is 16.
To view the following window, click Security > Access Authentication Control > Authentication
Server:
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
NOTE
More than one authentication protocol can be run on the same physical server host but, remember that
TACACS/XTACACS/TACACS+ are separate entities and are not compatible with each other.
Parameters Description
IP Address The IP address of the remote server host the user wishes to add.
Port (1-65535) Enter a number between 1 and 65535 to define the virtual port number of the
authentication protocol on a server host. The default port number is 49 for
TACACS/XTACACS/TACACS+ servers and 1812 for RADIUS servers but the
user may set a unique port number for higher security.
Protocol The protocol used by the server host. The user may choose one of the
following:
TACACS - Enter this parameter if the server host utilizes the TACACS
protocol.
XTACACS - Enter this parameter if the server host utilizes the XTACACS
protocol.
TACACS+ - Enter this parameter if the server host utilizes the TACACS+
protocol.
RADIUS - Enter this parameter if the server host utilizes the RADIUS protocol.
Timeout (1-255) Enter the time in seconds the Switch will wait for the server host to reply to an
authentication request. The default value is 5 seconds.
Key Authentication key to be shared with a configured TACACS+ or RADIUS
servers only. Specify an alphanumeric string up to 254 characters.
Retransmit (1-255) Enter the value in the retransmit field to change how many times the device
will resend an authentication request when the server does not respond. The
default value is 2 times.