Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Access Authentication Control Folder
Extreme Networks EAS 100-24t Switch Software Manual
123
To access the following window, click Security > Access Authentication Control > Authentication
Policy Settings:
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
Application Authentication Settings
This window is used to configure switch configuration applications (console, Telnet, SSH, HTTP) for
login at the user level and at the administration level (Enable Admin) utilizing a previously configured
method list.
To view the following window, click Security > Access Authentication Control > Application
Authentication Settings:
Parameters Description
Authentication Policy Use the pull-down menu to enable or disable the Authentication Policy on the
Switch.
Response Timeout (0-255) This field will set the time the Switch will wait for a response of authentication
from the user. The user may set a time between 0 and 255 seconds. The
default setting is 30 seconds.
User Attempts (1-255) This command will configure the maximum number of times the Switch will
accept authentication attempts. Users failing to be authenticated after the set
amount of attempts will be denied access to the Switch and will be locked out
of further authentication attempts. Command line interface users will have to
wait 60 seconds before another authentication attempt. Telnet and web users
will be disconnected from the Switch. The user may set the number of
attempts from 1 to 255. The default setting is 3.