Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
SSH Folder
Extreme Networks EAS 100-24t Switch Software Manual
119
To view this window, click Security > SSH > SSH Authmode and Algorithm Settings:
In this window, the following parameters can be configured:
Parameters Description
SSH Authentication Mode Settings
Password This parameter may be enabled if the administrator wishes to use a locally
configured password for authentication on the Switch. The default is enabled.
Public Key This parameter may be enabled if the administrator wishes to use a public key
configuration set on a SSH server, for authentication on the Switch. The
default is enabled.
Host-based This parameter may be enabled if the administrator wishes to use a host
computer for authentication. This parameter is intended for Linux users
requiring SSH authentication techniques and the host computer is running the
Linux operating system with a SSH program previously installed. The default
is enabled.
Encryption Algorithm
3DES-CBC Tick the check box to enable the Triple Data Encryption Standard encryption
algorithm with Cipher Block Chaining. The default is enabled.
Blow-fish CBC Tick the check box to enable the Blowfish encryption algorithm with Cipher
Block Chaining. The default is enabled.
AES128-CBC Tick the check box to enable the Advanced Encryption Standard AES128
encryption algorithm with Cipher Block Chaining. The default is enabled.
AES192-CBC Tick the check box to enable the Advanced Encryption Standard AES192
encryption algorithm with Cipher Block Chaining. The default is enabled.
AES256-CBC Tick the check box to enable the Advanced Encryption Standard AES-256
encryption algorithm with Cipher Block Chaining. The default is enabled.
ARC4 Tick the check box to enable the Arcfour encryption algorithm with Cipher
Block Chaining. The default is enabled.
Cast128-CBC Tick the check box to enable the Cast128 encryption algorithm with Cipher
Block Chaining. The default is enabled.
Twofish128 Tick the check box to enable the twofish128 encryption algorithm. The default
is enabled.
Twofish192 Tick the check box to enable the twofish192 encryption algorithm. The default
is enabled.
Twofish256 Tick the check box to enable the twofish256 encryption algorithm. The default
is enabled.
Data Integrity Algorithm