Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Chapter 5: Security
Extreme Networks EAS 100-24t Switch Software Manual
112
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
Authentication RADIUS Server
The RADIUS feature of the Switch allows you to facilitate centralized user administration as well as
providing protection against a sniffing, active hacker.
To configure the 802.1X User, click Security > 802.1X > Authentication RADIUS Server:
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
Parameters Description
802.1X User Specifies the 802.1X username used here.
Password Specifies the 802.1X password used here.
Confirm Password Specifies the 802.1X password confirmation used here.
Parameters Description
Index Choose the desired RADIUS server to configure: 1, 2 or 3.
IP Address Set the RADIUS Server IP.
Authentic Port
(1-65535)
Set the RADIUS authentic server(s) UDP port. The default port is 1812.
Accounting Port
(1-65535)
Set the RADIUS account server(s) UDP port. The default port is 1813.
Timeout (1-255) Enter the timeout value in seconds (1 to 255) the default value is 5.
Retransmit (1-255) Set the retransmit value in seconds (1 to 255) the default value is 2.
Key
(Max. length 32 bytes)
Set the key the same as that of the RADIUS server. Maximum length of the
entry is 32 bytes.