Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Chapter 5: Security
Extreme Networks EAS 100-24t Switch Software Manual
110
802.1X Settings
To configure the 802.1X Settings, click Security > 802.1X > 802.1X Settings:
In this window, the following parameters can be configured:
Parameters Description
802.1X Use the radio buttons to enable or disable 802.1X.
Auth Mode Here is authentication mode used will be displayed.
Auth Protocol Choose the authentication protocol, Local or RADIUS EAP.
From Port/To Port Enter the port or ports to be set.
QuietPeriod
(0-65535)
This allows you to set the number of seconds that the Switch remains in the
quiet state following a failed authentication exchange with the client. The
default setting is 60 seconds.
SuppTimeout
(1-65535)
This value determines timeout conditions in the exchanges between the
Authenticator and the client. The default setting is 30 seconds.
ServerTimeout (1-65535) This value determines timeout conditions in the exchanges between the
Authenticator and the authentication server. The default setting is 30 seconds.
MaxReq (1-10) The maximum number of times that the Switch will retransmit an EAP Request
to the client before it times out of the authentication sessions. The default
setting is 2.
TxPeriod
(1-65535)
This sets the TxPeriod of time for the authenticator PAE state machine. This
value determines the period of an EAP Request/Identity packet transmitted to
the client. The default setting is 30 seconds.