Installation manual

First Time Connecting to the Switch

Extreme Networks EAS 100-24t Switch Hardware Installation Manual

Figure 12: Initial screen after first connection

First Time Connecting to the Switch

The switch supports user-based security that can allow you to prevent unauthorized users from

accessing the switch or changing its settings. This section tells how to log onto the switch.

NOTE

The passwords used to access the switch are case-sensitive; therefore, "S" is not the same as "s."

When you first connect to the switch, you will be presented with the first login screen.

NOTE

Press Ctrl+R to refresh the screen. This command can be used at any time to force the console program

in the switch to refresh the console screen.

Enter the username and password and press Enter. You will be given access to the command prompt #

shown below. The default username is admin and there is no initial password.

Figure 13: Command Prompt

Password Protection

The switch does not have a default password. One of the first tasks when settings up the switch is to

create user accounts. Once logged in using a predefined administrator-level user name, users will have

privileged access to the switch's management software.

EAS 100-24t Gigabit Ethernet Switch

Command Line Interface

Firmware: Build 1.00.002

UserName:

EAS 100-24t Gigabit Ethernet Switch

Command Line Interface

Firmware: Build 1.00.002

UserName:admin

PassWord: