Installation guide

82 Consolidated "e" Series Hardware Installation Guide
Summit 300 Optional Features
Installing and Removing Power Cable Retaining Brackets
The power cable for the Summit 300-48 power supply can be attached to the supply using power cable
retaining brackets. The retaining brackets make it less likely that a power supply cable will be
inadvertently knocked loose from a power supply.
Installing the Power Cable Retaining Bracket
To install a power cable retaining bracket:
1 Turn off the power supply by setting the power switch to the OFF position.
2 Disconnect the power cable from the power source and then disconnect the Summit 300-48.
3 Slide the retaining bracket over the power cable, as shown in Figure 26.
If necessary, loosen the retaining bracket screw.
Figure 26: Attaching the retaining bracket
LB48021B
Retaining bracket screw