Installation guide

78 Consolidated "e" Series Hardware Installation Guide
Summit 300 Optional Features
Figure 22: EPS-LD cable with key
Figure 23: Cable connector for connecting an EPS-LD unit to a switch
3 Connect the AC input power cable to the AC connector on the EPS-LD unit.
CAUTION
The EPS-LD unit does not have a switch for turning the unit on and off. You disconnect power to the
EPS-LD unit by removing the plug from the electrical outlet. Ensure that this connection is easily
accessible to you.
4 Connect the other end of the AC cable into the electrical outlet.
Ensure that the electrical outlet is properly grounded.
NOTE
Consider all the equipment connected to the power supply circuit to ensure that the circuit is not
overloaded. Use proper overcurrent protection, such as a circuit breaker, to prevent overcurrent
conditions.
The Power LED on the front of the EPS-LD unit turns solid green to indicate that it is ready. Table 16
shows the possible LED status for the power supply.
Table 16: LED status for EPS-LD Power LED
Power LED Indicates
Green, solid
Off
The external power supply is operating normally.
The external power supply is not connected.
Collin's
ES4K027
XM_05
5
Collin's
Slot for key
Keyed end of
redundant power cable
To AC
To AC
Extreme switch
EPS-LD
Redundant
power cable