Installation guide

70 Consolidated "e" Series Hardware Installation Guide
“e” Switch Installation
Figure 19 shows the pin-outs for a 9-pin to RS-232 25-pin null-modem cable.
Figure 19: Null-modem cable pin-outs
Figure 20 shows the pin-outs for a 9-pin to 9-pin PC-AT null-modem serial cable.
Figure 20: PC-AT serial null-modem cable pin-outs
Powering On the SwitchSummit 300-48 switch
Connect the AC power cable to the switch and then to the wall outlet. The Summit 300-48 has the
additional requirement to turn the power switch on the back panel to the on position..
Checking the InstallationSummit 300-48 switch
After connecting power to the switch, the device performs a Power On Self-Test (POST).
During the POST, all ports are temporarily disabled, the port LED is off, and the MGMT LED flashes.
The MGMT LED flashes until the switch successfully passes the POST.
If the switch passes the POST, the MGMT LED blinks at a slow rate (one blink per second). If the switch
fails the POST, the MGMT LED shows a solid amber light.
Screen
TxD
RxD
Ground
RTS
CTS
DSR
DCD
DTR
C
able connector: 9-pin female
S
ummit
Cable connector: 25-pin male/fema
le
PC/Terminal
Screen
RxD
TxD
Ground
RTS
DTR
CTS
DSR
DCD
Shell
3
2
5
7
8
6
1
4
1
3
2
7
4
20
5
6
8
ser_sum
1
Screen
DTR
TxD
RxD
CTS
Ground
DSR
RTS
DCD
C
able connector: 9-pin female
S
ummit
Cable connector: 9-pin fema
le
PC-AT Serial Port
Screen
DCD
RxD
TxD
DTR
Ground
DSR
RTS
CTS
Shell
4
3
2
8
5
6
7
1
Shell
1
2
3
4
5
6
7
8
ser_sum
2