Installation guide

66 Consolidated "e" Series Hardware Installation Guide
“e” Switch Installation
Rack Mounting
CAUTION
Do not use the rack mount kits to suspend the switch from under a table or desk, or to attach the switch
to a wall.
To rack mount the Summit 200 series switch:
1 Place the switch upright on a hard flat surface, with the front facing you.
2 Remove the existing screws from the sides of the case (retain the screws for Step 4).
3 Locate a mounting bracket over the mounting holes on one side of the unit.
4 Insert the screws and fully tighten with a suitable screwdriver, as shown in Figure 17.
Figure 17: Fitting the mounting bracket
5 Repeat steps 2 through 4 for the other side of the switch.
6 Insert the switch into the 19-inch rack.
• Take care to load the rack so that it is not top-heavy.
• Do not cover vents that would restrict airflow. Leave a half-rack space between the units for
adequate ventilation. This space is especially important for Summit 400-48t switches that have the
optional ER XENPAK transceiver installed.
7 Secure the switch with suitable screws (not provided).
8 Connect the switch to the redundant power supply (if applicable).
9 Connect cables.
LC24003
LB48004
ES4K002