Installation guide

14 Consolidated "e" Series Hardware Installation Guide

Overview of the “e” Series of Switches

• 24 autosensing 10BASE-T/100BASE-TX ports using RJ-45 connectors

• Two 10/100/1000BASE-T Gigabit Ethernet uplink ports using RJ-45 connectors

• Two optical ports that allow Gigabit Ethernet uplink connections through Extreme 1000BASE-SX,

1000BASE-LX, or 1000BASE-ZX Small Form Factor pluggable (SFP) Gigabit Interface Connectors

(GBICs)—also known as mini-GBICs—using LC optical fiber connectors. Mini-GBICs are purchased

separately, for more information contact your Extreme Networks Sales Representative.

Software Features

This section describes the features of the different Summit series. If the information in the release notes

differs from the information in this guide, follow the release notes. For more information about

configuring the switch, refer to the ExtremeWare Software User Guide and The ExtremeWare Command

Reference Guide.

The Summit 200 series switches support the following ExtremeWare features:

• Virtual local area networks (VLANs) including support for IEEE 802.1Q and IEEE 802.1p

• Spanning Tree Protocol (STP) (IEEE 802.1D)

• Rapid Spanning Tree Protocol (IEEE 802.1W)

• Quality of Service (QoS) including support for IEEE 802.1p, MAC QoS, and four hardware queues

• Wire-speed Internet Protocol (IP) routing

• DHCP/BOOTP Relay

• Network Address Translation (NAT)

• Extreme Standby Router Protocol (ESRP)

• Ethernet Automated Protection Switching (EAPS) support (RFC 3619)

• Simple Network Time Protocol (SNTP)

• Protocol Multicast-Sparse Mode (PIM-SM)

• Virtual Router Redundancy Protocol (VRRP)

• Routing Information Protocol (RIP) version 1 and RIP version 2

• Open Shortest Path First (OSPF) routing protocol

• DiffServ support

• Access-policy support for routing protocols

• Access list support for packet filtering

• Access list support for rate-limiting

• IGMP snooping to control IP multicast traffic

• Load sharing on multiple ports

• Dynamic load sharing on multiple ports

• RADIUS client and per-command authentication support

• TACACS+ support

• Network login

• Console command-line interface (CLI) connection

• Telnet CLI connection

• SSH2 connection