Specifications

Open Issues, Known Behaviors, and Resolved Issues
ExtremeXOS 12.5.4 Release Notes
71
PD4-1883558321 When using IdMgr, the configure identity-management add port all
command is not enabling IdMgr on any ports.
Workaround: Use the configure identity-management add port <portlist>
command to enable IdMgr on ports.
PD4-1687877872 A switch hangs while adding 49 RIPng processes to a user VR and is then rebooted with
seven processes already in the default VR.
PD4-1688055111 A system crash occurs when the system is configured with 2,000 VPLS and 1,000 CFM
instances while running the restart ports, or save and reboot commands.
PD4-1770890688,
PD4-770508534
If the configure ip-mtu command is configured on VLANs that have only an IPv6
address, the show configuration command does not display the output for the
configure ip-mtu command.
PD4-1844559626 After configuring a banner, if a configuration with no banner is used, the banner
configured earlier is displayed.
PD4-1535268856 ISIS neighborship goes down when the hello interval is set to minimal.
PD4-1567053191 ISIS goes to Init state and provides a negative HoldTime when redistributing 40,000
OSPF routes into ISIS.
PD4-1636566851 ISIS crashes with signal 11 when performing an ISIS process restart after a MIBwalk with
255 adjacencies.
PD4-1630086161 Creating and additional 100 PIM VLANs when a system has 2,000 (S, G) entries with
100 egress VLANs causes a PIM process crash.
PD4-1540274936 An ISIS process crash with signal 6 may occur when disabling ISIS when ISISv6 and
ISIS IP route compression are configured.
PD4-1624707485 In an IdMgr configuration, a DUT does not show unknown entries if a client or server port
is configured with a static IP address and connected to an L2 network.
PD4-1584840651 The ethernet OAM half-link feature is not supported in ExtremeXOS 12.5.1.
PD4-1556309411 With multiple NSSA areas where there is more than one link between areas, OSPF
default routes are not installed in the routing table.
PD4-1549189647 In ISIS, when route summarization is configured with authentication, the authentication is
not effective and all the routes are advertised, regardless of the type of authentication
configured.
PD4-1535268629 ISIS tx-only authentication also authenticates received LSPs. The received routes are not
installed in the ISIS LSDB based on the authentication policy.
PD4-1620486143 When DHCP lease time is set to the maximum/infinity (4294967295), the DHCP client
continuously sends renewal requests.
PD3-57182431 For the incoming traffic with alignment errors, the "RX Align" counter in the output of the
show ports <port number> rxerrors command is not incremented. Instead, the
"RX CRC" counter is incremented.
PD4-813961562 When a service VLAN is changed to include a dot1q tag on both sides in CFM VPLS, the
RMEP entry is not learned on one side.
PD4-749060484 Errors are seen when a configuration having identifiers (SNMPv3 user name/EAPS
domain name) with special characters are loaded through a script.
PD4-561358261 If you create a super VLAN and a sub-VLAN in different virtual routers you are able to
bind the VLANs. Super VLANs and sub-VLANs should belong to the same virtual router.
PD4-460892051 Installing different versions of an ExtremeXOS image and an SSH image displays the
following error message:
Failed to install image- cannot read spec file" in the log
"upgrade failed installation:got error from installer DLL"
Table 38: Open Issues, Platform-Specific and Feature PDs (Continued)
PD Number Description