Specifications

Overview
ExtremeXOS 12.5.4 Release Notes
19
NOTE
Use the check firmware version command to verify that all components on the BlackDiamond 20800
series switches (I/O modules, fans, and so on) are running the latest version of ExtremeXOS firmware. If the
command output shows that one or more component is not running the latest firmware, use the install
firmware command to update all down level components. Be sure to run the show slot, show fans, show
power, and show fabric commands to verify that all components are installed and operational before attempting
to upgrade or downgrade the switch firmware.
Summit X150 and X350 Component Support
Summit X150 and X350 series components supported with ExtremeXOS 12.5, and the minimum
BootROM version required by the switch to support each component, include:
MM Basic
uC
FPGA: S
BootROM
PSUCTRL
bd20k-12.5.4.5.xos 12.3.2
2.9
0.3.e
0.2.1
3.0
Fan Tray (BlackDiamond 20808)
uC (shown as “Revision”)
N/A 12.3.2
2.9
Fan Tray (BlackDiamond 20804)
uC (shown as “Revision”)
N/A 12.4.1
2.9
Table 6: Summit X150 and X350 Component Support
Summit X150 and X350
Components ExtremeXOS Filenames
Minimum
ExtremeXOS
Required
Minimum
BootROM
Version
Summit X150-24t summitX-12.5.4.5.xos 12.0.2.25 1.0.3.1
Summit X150-48t summitX-12.5.4.5.xos 12.0.2.25 1.0.3.1
Summit X150-24p summitX-12.5.4.5.xos 12.0.2.25 1.0.3.1
Summit X350-24t summitX-12.5.4.5.xos 12.0.3.16 1.0.3.1
Summit X350-48t summitX-12.5.4.5.xos 12.0.3.16 1.0.3.1
XGM2-2xf (Summit X350 only) summitX-12.5.4.5.xos 12.1.2 N/A
XGM2-2sf (Summit X350 only) summitX-12.5.4.5.xos 12.2.1 N/A
XGM2-2bt (Summit X350 only) summitX-12.5.4.5.xos 12.2.1 N/A
Table 5: BlackDiamond 20800 Series Switch Component Support (Continued)
BlackDiamond 20800 Components ExtremeXOS Filenames
ExtremeXOS
Required
Firmware Version
Required with
ExtremeXOS 12.5.3