Specifications
Page 34 ExtremeWare v6.2.1 Release Notes
Release Notes for ExtremeWare v6.2.1
In this case, Rule 4 is the rule with the best match as it again contains an explicit Destination IP Port.
NetFlow
If a flow record filter is configured on one port with type “match-all-flows” you cannot configure the
same flow filter on any other port. (1-7G1D8)
WEB Management - VISTA
Closing Internet Explorer 4.0
IE 4.0 caches user login information. In some environments, this can be a security issue. As a
work-around, it is best to close the browser after logging out of the switch (1873, 1994).
Vista and RADIUS
If a switch configured for RADIUS authentication loses communication with the RADIUS server,
subsequent attempts to use the Vista Web application will take a very long time (measured in several
minutes). When communication is lost with the RADIUS server, Vista will continue to make
authentication requests for every page. Each request has a timer that will expire leading to an excessive
amount of time to bring up each page (5144).
If Radius is enabled on a switch, Vista is supported in read-only mode only (8887). The statistics menu
can be viewed but the configuration menu will not be accessible.
Configuration Options with Large Number of Interfaces
When selecting a configuration applet with a large number of configured interfaces, the traversal of the
VLAN interfaces by Vista can cause a Watchdog reset due to the task utilization of Vista during the
interface data collection. It is recommended that Vista not be used for configurations with Watchdog
enabled where the Vista Configuration applet is used with a large number of VLAN interfaces.
SNMP
Trap Receivers as Broadcast Entry
Although it is possible to enter a broadcast or IP multicast address as an SNMP trap receiver, it will not
function (2545).
Control of UDP Port used in Sending Traps
The control of what UDP port number to be used when sending SNMP traps can be done through the
appropriate attributes in RFC 2021. It cannot be currently controlled through CLI and is not stored as
part of a configuration (4914).
192.168.2.0/24 80 ANY 2
192.168.0.0/16 ANY 10.10.10.0/24 4
192.168.2.0/24 ANY 10.10.0.0/16 3
192.168.2.0/24 80 10.10.0.0/16 1