User guide

MPLS Module Installation and User Guide Index - iii
binding 3-10
configuring label advertisement filters 4-7
configuring propagation filters 4-6
definition of 1-6, 3-3
displaying mappings 3-21
length 3-2
locally assigned 3-10
NULL label, advertising 4-2
popping 3-11
propagating 4-2
remotely assigned 3-10
retention modes 3-5
space partitioning 3-10
swapping 3-2, 3-3, 3-11
label-switch forwarding algorithms 3-1
layer-3 switching 9-10
LDP
advertising label mappings in TLS 7-3
configuration commands (table) 4-4
configuring filters 4-6
definition of 3-3, 4-1
hello-adjacency 4-2
message exchange 4-2
neighbor discovery protocol 4-1
propagation filters
configuring 4-7, 4-8
route maps 4-7, 4-8
session timers, configuring 4-8
targeted sessions 4-2
LED indicators 1-4, 2-8, 2-10
LER
definition of 3-3
described 3-6
liberal label retention mode 3-5
load-sharing 6-4
local routing database 5-1
locally assigned labels 3-10
longest prefix match 1-8
LPS
tunnel, definition of 3-4
LSP
and TLS 7-2
and TLS tunnels 6-5
control modes 3-6
definition of 3-3
direct 6-2
equal cost 6-4
indirect 6-2
load-sharing 6-4
multivendor support for indirect 6-6
overriding IGP path cost 6-5
precedence 6-4
routing 6-2
scaling 5-13
LSR
definition of 3-3
egress, definition of 3-6
functions (table) 3-7
ingress, definition of 3-6
LER, description of 3-6
locally assigned labels 3-10
remotely assigned labels 3-10
M
maximum transmission unit (MTU) 5-6
Maximum Transmission Unit. See MTU
MIBs A-1
MPLS
and OSPF AS 6-1
configuration commands (table) 3-12
configuration example (figure) 4-10
configuring interfaces 3-15
definition of 1-2, 1-6, 3-1, 3-3
displaying information 3-20
label stack 3-8
resetting configuration parameters 3-19
routing IP unicast packets 6-1
sample network (figure) 3-2
shim layer 3-8
terms and acronyms (table) 3-2
MPLS module
component 1-3
conditions for replacing 2-13
diagnostics 2-13
GPP subsystem 1-4
hardware requirements 2-2
hot-swapping 1-5
installing 2-1, 2-6
LED indicators 1-4, 2-8, 2-10
network processors 1-4
physical description 1-2
removing and replacing 2-14
software requirements 2-2
troubleshooting 2-9
upgrading the software image 2-11
verifying operation 2-8
MTU
configuring 3-16
fragmentation 3-16
jumbo frames, supporting 3-16
MultiProtocol Label Switching. See MPLS
N
neighbor discovery protocol, LDP 4-1
network processors 1-4
Next Hop Label Forward Entry (NHLFE),
definition of 3-3