User guide

MPLS Module Installation and User Guide 9-5
VLAN Commands
VLAN Commands
Most of the VLAN commands are not directly applicable to the MPLS module. The two
exceptions are:
• The
show vlan
command has been enhanced to indicate whether MPLS is enabled
or disabled on the VLAN.
• Implementations of the
config vlan delete port
and
unconfig vlan <name>
ipaddress
commands have been augmented to support the MPLS module.
All frames received and transmitted by the MPLS module include a VLAN tag.
FDB Commands
The following FDB commands have been augmented to support the MPLS module:
• The
clear fdb
command clears the VPN source MAC address cache for all MPLS
modules. If the optional
<mac_address>
or
<vlan_name>
parameters are specified,
any VPN cache entry that matches the specified parameters are cleared.
• The
show fdb
command has been augmented to display the TLS tunnel on which
the MAC address was learned.
• The
config fdb agingtime <number>
command can be used to age TLS Layer-2
VPN MAC addresses cached on the MPLS module.
All frames received and transmitted by the MPLS module include a VLAN tag.
Basic IP Commands
The implementation of the following commands has been augmented to support the
MPLS module:
•
enable ipforwarding {vlan <name>}
•
disable ipforwarding {vlan <name>}
•
show ipconfig {vlan <name>}
•
rtlookup [<ipaddress> | <hostname>]