Specifications

Issues Resolved in ExtremeWare 7.4.3b5
ExtremeWare 7.4.3 Installation and Release Notes 73
BlackDiamond
Stand-alone BlackDiamond 6808 switches with an F48Ti module installed no longer experience high
port utilization (PD3-42179804).
Summit
On a Summit 300-48 switch, the tRootTask no longer crashes, causing the switch to reboot in a loop
(PD3-55381783).
On a Summit 200 switch, the internal setting for the gigabit ports (25, 26) signal detect level is now
correct (PD3-51650617.
Redundant ports on a Summit 200 switch now work normally if the redundant port is a fiber port
(PD3-48957841).
The watchdog timer no longer expires after configuring an ACL rule on a Summit 200-48 switch
(PD3-36947251).
The gigabit port I/O module voltage has been reset to 2.5 V on Summit 200 switches (PD3-52558235,
PD3-48564913).
Summit 300-48 switches no longer fail after rebooting when wireless is not enabled (PD3-48946414).
Running the
show switch command on a Summit 300-48 switch with an empty (default) configuration
no longer generates the following message:
:
<Erro:KERN> NV:readImageTime: failed reading memory from FLASH (2)
(PD3-36934571)
ACL
Access-profiles with subnet entries set to deny now work even though the major network is set to
permit (PD3-22951023).
Bridging
Source MAC refresh is no longer causing multicast traffic to be out of order (PD3-55235712).
The tBGTask no longer crashes when processing IGMP snoop data input (PD3-53419191).
EAPS links are no longer reported as down when the primary link in a load-share configuration goes
down (PD3-51289451).
NetBIOS protocol based VLANs now recognize LLC f0f1 packets (PD3-45191631).
CLI
T3 ports can now be added to multiple VLANs without generating an incorrect error message
(PD2-149180105).
The switch no longer hangs when displaying the
configure lacp keep-alive 3 command when
executing the s
how configuration command (PD3-29936386).