Specifications

70 ExtremeWare 7.4.3 Installation and Release Notes
Clarifications, Known Behaviors, and Resolved Issues
show wireless ports detail Output Shows Incorrect BootStrap/BootLoader Version
The show wireless ports <port> detail command shows the incorrect bootstrap and bootloader
version for the AP when the AP is running an older bootrom version (1.5.2).
# show wireless ports 2 detail
...
Hardware Version: 01010001
Software Version: v7.3.1
Bootstrap Version: v0.0.0
Primary Bootloader Ver: v64.240.254 (Booted)
Secondary Bootloader Ver: v212.240.254
On a Summit 300-48, the APs bootstrap and bootloader software are upgraded automatically. On a
Summit 400-24p, Summit 300-24, and Alpine switches the upgrade facility is not available. Therefore,
the issue of incorrect version display is only seen on Summit 400-24p, Summit 300-24, and Alpine
switches (PD3-35947955).
Stacking and UAA Functionality
UAA functionality is stated to be available on a master slot of a stack in the ExtremeWare 7.4 User Guide.
This is incorrect. UAA is not supported on any stacking. This will be corrected in future updates of the
ExtremeWare 7.4 User Guide (PD3-36334122).
Wireless Network Login ISP Mode Shown in the Incorrect State
When the switch is configured for ISP mode and a wireless client is successfully authenticated using
Network Login, the
show wireless ports interface clients detail command correctly shows
the wireless client to be in the FORWARD state. However, if the client logs out and is re-authenticated,
the
show wireless ports interface clients detail command shows the wireless client to be in
the ASSOC state (PD3-36087675).
Wireless Network Login User May be able to Access Network Resources
When an authenticated wireless Network Login client disconnects using the client software, instead of
using the logout popup window, the Network Login session is sometimes not cleared in the switch. As
a result, when the client reconnects to the AP, the client can access network resources even though the
client is in the unauthenticated state (PD3-35950208).
show wireless ports detail Output Shows Incorrect Software Version
The show wireless ports <port> detail command shows the incorrect software version for the AP.
The software version should read v 7.4.1.
# show wireless ports 1 : 14 det
...
Hardware Version: 01010001
Software Version: v7.3.1
(PD3-35950133)
Wireless Client Cannot Move to a Permanent VLAN
A wireless client cannot move to a permanent VLAN if ISP mode is changed to Campus mode on the
same port.