Specifications

Clarifications and Known Behaviors
ExtremeWare 7.4.3 Installation and Release Notes 65
EAPS
Flushing Selective FDB Entries is not Working Properly on an EAPS Domain
Selective flushing of FDB entries belonging to a protected VLAN is not working correctly. Instead, the
switch flushes all FDB entries, including those for non-protected VLANs (PD3-37488841).
ESRP
Rate-shaped ESRP Slave Interface Loses Some of the ESRP Hello Packets
A rate-shaped ESRP slave interface loses some of the ESRP hello packets from the master and flips
between the slave and pre-master state when the election parameters suit the slave to win the ESRP
election (PD3-26798641).
PoE
Default PoE Algorithm on All Ports is max-class-operator
The default setting for all ports on a Summit 300-48 switch is max-class operator and advertised
class
. The maximum class operator is by default set for 15.4 W, or Class 3 only. The default setting
should be
advertised class.
Workaround. To set all ports to be
advertised-class the procedure is as follows.
1 Issue the
disable inline-power command.
2 Issue the
config inline-power violation-precedence advertise-class ports all
command.
(PD3-26067537)
RADIUS
Authentication With Secondary Radius Server Fails After Switch Reboot
Assuming both the primary and the secondary RADIUS servers are configured, when you unconfigure
the primary RADIUS server, the failover to the secondary RADIUS server happens correctly. The
wireless client is able to be authenticated using a secondary RADIUS server, but after the switch
reboots, authentication is not successful with the secondary RADIUS server (PD3-36227684).
Routing
Exported Static Route in ISIS is Advertised After Removing the VLAN and Static Route
If a VLAN is removed prior to removing a static route, the exported static route is not removed, even
after removing the static route configuration.
Workaround. Remove the static route before deleting the VLAN with the gateway IP address.