Specifications

Upgrading ExtremeWare on Summit 200/300/400 Series Switches Using the CLI
ExtremeWare 7.4.3 Installation and Release Notes 43
3 Save the configuration using the save configuration command.
4 Download the ExtremeWare 7.4 image, v743b5.Fxtr.
5 Reboot the switch using the
reboot command.
6 The upgrade should not affect the running configuration. If you do not have the appropriate
configuration downloaded, reconfigure the switch or download the original configuration saved in
step 1. This step is optional.
Upgrading a Summit 300-48
Upgrade a Summit 300-48 as follows:
1 Verify an ExtremeWare version of at least v62a120b422 is running on the Summit 300-48 using the
show switch command.
2 If the switch is running the minimum required version, go to step 6.
3 Download v62a120b422.
4 Save the configuration using the
save configuration command.
5 Reboot the switch using the
reboot command.
6 Upload the current configuration to a TFTP server.
7 If the switch is running ExtremeWare 7.3 or earlier, download ExtremeWare 7.3 image v73e0b43.Lxtr.
Otherwise, proceed to step 9.
8 Save the configuration using the
save configuration command.
9 Download ExtremeWare 7.4 image v743b5.Lxtr.
10 Reboot the switch using the
reboot command.
11 Download the configuration you saved in step 6. For example:
download config 10.60.112.254 saved.cfg incremental
Upgrading a Summit 400-48t to ExtremeWare 7.4
Upgrade a Summit 400-48t to ExtremeWare 7.4 as follows:
1 Upload the current configuration to a TFTP server.
2 Verify the current BootROM is version 5.1. If the BootROM is version 5.1, go to step 3, otherwise
download the BootROM: s400_boot51.bin and reboot the switch.
NOTE
If the switch does not accept the BootROM or the image, ensure the 10G2XN module is installed. If
the module is installed, remove the module (not just the GBICs but the entire module) from the
switch. This module is not hot swappable; power off the switch before removing. The 10 Gig
XGM-2XN module is supported in ExtremeWare 7.4 and later. You cannot upgrade or downgrade a
Summit switch running an ExtremeWare release earlier the ExtremeWare 7.4.
3 If the switch is running ExtremeWare 7.3 or earlier, download ExtremeWare 7.3 image v73e0b43.Cxtr.
Otherwise, proceed to step 5.
4 Save the configuration using the
save configuration command.
5 Download ExtremeWare 7.4 image v743b5.Cxtr.
6 Reboot the switch using the
reboot command.