Specifications

18 ExtremeWare 7.4.3 Installation and Release Notes
Overview
GBIC Support
GBICs supported with ExtremeWare 7.4, and the minimum ExtremeWare version required, include:
The following table describes how each version of ExtremeWare interprets the media type of the
installed GBIC, based on either the Vista web interface, or the
show port configuration command.
All versions correctly identify Parallel ID GBIC types; however, some versions do not correctly identify
the Serial ID GBIC type because the Serial ID GBICs were introduced after the software was released.
Summit48si DC Power Supply 7.1.1
2
1. Older switches do not require ExtremeWare 6.2.2b56. To determine the
minimum revision required for your switch, see Field Notice 115A, here:
http://www.extremenetworks.com/services/documentation/FieldNotices_
FN0115-MACAddressSoftwareReqmt.asp.
2. ExtremeWare 6.2.2 recognizes the Summit48si DC power supply, but
does not indicate the type of PSU installed, issue a warning if both an
AC and a DC PSU are installed in the same chassis, or send an SNMP
trap message when the PSU is hot-swapped.
Table 6: GBIC support
GBIC ExtremeWare Required
SX parallel ID 1.0
SX serial ID 2.0
LX parallel ID 1.0
LX serial ID 2.0
ZX 6.2.2
ZX Rev 03 6.2.2
LX70 2.0
LX100 6.1.9
UTP 6.1.9
SX Mini 7.0.1b11
LX Mini 7.0.1b11
ZX Mini 7.0.1b11
Table 7: ExtremeWare recognition of GBIC type
ExtremeWare
Version
SX Parallel ID LX Parallel ID SX Serial ID LX Serial ID LX70
1.x SX LX Not Supported Not Supported Not Supported
2.x SX LX LX LX LX
3.x SX LX CX CX CX
4.x SX LX SX LX LX
6.x SX LX SX LX LX70 (6.1.6 and
above)
Table 5: Summit component support
Summit Component ExtremeWare Required