Installation guide

3-4 B
LACK
D
IAMOND
H
ARDWARE
I
NSTALLATION
G
UIDE
S
ERVICE AND
M
AINTENANCE
R
EMOVING AND
R
EPLACING THE
F
AN
T
RAY
The BlackDiamond fan tray is hot-swappable. You do not need to turn off power to the
BlackDiamond to replace the fan tray. Access to the fan tray is from the rear of the
BlackDiamond chassis.
To remove and replace the fan tray, follow these steps:
1 Unscrew the ten screws securing the fan tray to the chassis, as shown in Figure 3-2.
Figure 3-2:
Removing the fan tray
2 Pull the fan tray straight back out of the chassis approximately ½ inch; this step
disconnects the power, causing the fans to stop.
3 Allow the fan blades to stop spinning before removing the fan tray completely.
Avoid personal injury. Keep hands away from rotating fan blades.
4 Insert the new fan tray into the bay.
5 Tighten the fan tray using the screws you removed in Step 1.
BD_fanx