Installation guide

B
LACK
D
IAMOND
H
ARDWARE
I
NSTALLATION
G
UIDE
2-7
P
OWERING
O
N THE
S
YSTEM
c To secure the MSM in the chassis, close the ejector/injector handles by pushing
on them toward the center of the module card, and tighten the screws using a
#1 Phillips-head screwdriver.
d Repeat this procedure for the second MSM, if applicable.
The MSM can be installed in Slot A or Slot B only. The MSM does not fit in any
other chassis slots. Forceful insertion will damage the MSM module or
backplane connectors.
10 Install the I/O module by following these steps:
a Ensure that the I/O module is right side up, and the ejector/injector handles are
extended.
b Slide the I/O module into the appropriate slot of the chassis (Slots 1 through 8),
until it is fully seated in the backplane.
When the I/O module is fully seated in the chassis, the ejector/injector handles
will begin to close.
c To secure the module in the chassis, close the ejector/injector handles by pushing
on them toward the center of the module card, and tighten the screws using a #1
Phillips-head screwdriver.
d Repeat this procedure for the additional I/O modules, if applicable.
The I/O module can be installed in any of the slots labeled Slot 1 through Slot 8
only. The I/O module does not fit in Slot A or Slot B. Forceful insertion will
damage the I/O module or backplane connectors
P
OWERING
O
N THE
S
YSTEM
To turn on power to the system, connect the AC power cable to the power supply and
then to the wall outlet. If you have installed two power supplies, connect both power
cables.
C
HECKING THE
I
NSTALLATION
After turning on power to the BlackDiamond, each MSM performs a power-on self test
(POST) of its circuitry. The LED labeled “SYS” on the MSM blinks amber during the
POST. Once the MSM is operational, each I/O module performs a POST.