Installation guide

2-4 B
LACK
D
IAMOND
H
ARDWARE
I
NSTALLATION
G
UIDE
I
NSTALLATION AND
S
ETUP
Figure 2-2:
BlackDiamond chassis mounted in rack
4 Once the chassis is secured, remove the helper bracket.
5 Install the first power supply in an empty power supply bay by following these
steps:
a Ensure that the power supply is right side up, and the locking handle is open.
b Slide the power supply into the bay.
c Secure the power supply by rotating the locking handle up until it clicks in place,
and then tighten the screws using a #1 Phillips-head screwdriver.
BDinrack
1234AB5678