Installation guide
B
LACK
D
IAMOND
H
ARDWARE
I
NSTALLATION
G
UIDE
1-15
B
LACK
D
IAMOND
6800 C
OMPONENTS
All F32T ports use standard RJ-45 connectors and support 10BASE-T and 100BASE-TX.
The default configuration of the F32T module is as follows:
• All ports are added to the default VLAN as untagged.
• All ports inherit the properties of the default VLAN (protocol type, VLANid, and so
on).
• All ports are in auto-negotiation mode allowing 10 Mbps, 100 Mbps, full-duplex, or
half-duplex operation.
F32F M
ODULE
The F32F module, shown in Figure 1-7, has 32 100 Mbps Ethernet ports.
Figure 1-7:
F32F module
All F32F ports use standard MT-RJ connectors and support 100BASE-FX. The default
configuration of the F32F module is as follows:
• All ports are added to the default VLAN as untagged.
• All ports inherit the properties of the default VLAN (protocol type, VLANid, and so
on).
• All ports are in 100 Mbps, full-duplex mode.
BD_F32F
Port status LEDs
Module status LEDs
100 Mbps
ports
52020
3
4
2
1
11
12
10
9
19
20
18
17
27
28
26
25
7
8
6
5
15
16
14
13
23
24
22
21
31
32
30
29
STATUS
DIAG
AMBER
GREEN
FLASHING GREEN
=
=
=
ACTIVITY
LINK OK
DISABLED
4
1
20
17
8
5
24
21
12
9
28
25
16
13
32
29