Installation guide

3-4 B
LACK
D
IAMOND
S
WITCH
H
ARDWARE
I
NSTALLATION
G
UIDE
S
ERVICE AND
M
AINTENANCE
Caution: Do not slam the power supply into the backplane.
7
Secure the power supply by pushing down on the locking handle until it clicks in
place, and then tighten the screws using a #1 Phillips-head screwdriver.
R
EMOVING AND
R
EPLACING THE
F
AN
T
RAY
The BlackDiamond 6800 fan tray is hot-swappable. You do not need to turn off power
to the BlackDiamond 6800 switch to replace the fan tray. Access to the fan tray is from
the rear of the BlackDiamond 6800 chassis.
To remove and replace the fan tray, follow these steps:
1
Unscrew the ten screws securing the fan tray to the chassis, as shown in Figure 3-2.
Figure 3-2:
Removing the fan tray
2
Pull the fan tray straight back out of the chassis approximately ½ inch; this step
disconnects the power, causing the fans to stop.
3
Allow the fan blades to stop spinning before removing the fan tray completely.
BD_fanx