User guide

4-18 B
LACK
D
IAMOND
U
SER
G
UIDE
V
IRTUAL
LAN
S
(VLAN
S
)
The following example defines a protocol filter, myprotocol and applies it to the VLAN
named myvlan. This is an example only, and has no real-world application.
create protocol myprotocol
config protocol myprotocol add etype 0xf0f0
config protocol myprotocol add etype 0xffff
create vlan myvlan
config myvlan protocol myprotocol
D
ISPLAYING
VLAN S
ETTINGS
To display VLAN settings, use the following command:
show vlan {<name> | all}
Sample output from this command is as follows:
show vlan all
VLAN Interface [1-fde] with name “net142” created by user
Tagging: Untagged (Internal tag 4095)
IP: Not configured. IGMP Snooping is disabled
STPD: Domain “s0” is running spanning tree protocol.
Protocol AppleTalk = SNAP:809b SNAP:80f3
QoS Profile: QP1
Ports: 4. (Number of active port=5)
Untag: 1:1 1:2 1:3 1:10
LAN Interface [2-fdd] with name “net123” created by user
Tagging: Untagged (Internal tag 4094)
IP: 123.45.67.1/255.0.0.0
STPD: Domain “s0” is running spanning tree protocol.
Protocol Match all unfiltered protocols.
QoS Profile: QP1
Ports: 15. (Number of active port=1)
Untag: 2:6 2:7 2:8 2:9 2:10 2:11 2:12 2:13
2:14 2:15 6:2 6:3 6:4