User guide

2-22 B
LACK
D
IAMOND
U
SER
G
UIDE
A
CCESSING
T
HE
S
YSTEM
R
ESETTING AND
D
ISABLING
SNMP
To reset and disable SNMP settings, use the commands in Table 2-8.
C
HECKING
B
ASIC
C
ONNECTIVITY
The BlackDiamond offers the following commands for checking basic connectivity:
•
ping
•
traceroute
P
ING
The
ping
command enables you to send Internet Control Message Protocol (ICMP) echo
messages to a remote IP device. The
ping
command is available for both the user and
administrator privilege level.
The
ping
command syntax is
ping {continuous} {size <n>} <ip_address>
Options for the ping command are described in Table 2-9.
If a
ping
request fails, the system continues to send
ping
messages until interrupted.
Press any key to interrupt a
ping
request.
Table 2-8:
SNMP Reset and Disable Commands
Command Description
disable snmp access Disables SNMP on the system.
disable snmp trap Prevents SNMP traps from being sent from the system.
Does not clear the SNMP trap receivers that have been
configured.
unconfig management Restores default values to all SNMP-related entries.
Table 2-9:
Ping Command Parameters
Parameter Description
continuous
Specifies ICMP echo messages to be sent continuously.
This option can be interrupted by pressing any key.
size <n>
Specifies the size of the packet.