User guide

9-16 B
LACK
D
IAMOND
U
SER
G
UIDE
R
OUTING
P
ROTOCOLS
config ospf area delete range <ipaddress>
<mask>
Deletes a range of IP addresses in an OSPF
area.
config ospf routerid [automatic | <routerid>] Configures the OSPF router ID. If automatic is
specified, the switch uses the largest IP
interface address as the OSPF router ID. The
default setting is
automatic
.
config ospf [vlan <name> | area <areaid> |
virtual-link <routerid>] timer
<retransmission_interval>
<transmission_delay> <hello_interval>
<dead_interval>
Configures the timers for one interface or all
interfaces in the same OSPF area. The
following default, minimum, and maximum
values (in seconds) are used:
■
retransmission_interval
Default: 5
Minimum: 0
Maximum: 3600
■
transmission
_
delay
Default: 1
Minimum: 0
Maximum: 3600
■
hello
_
interval
Default: 10
Minimum: 1
Maximum: 65535
■
dead
_
interval
Default: 40
Minimum: 1
Maximum: 2147483647
config ospf spf-hold-time {<seconds>} Configures the minimum number of seconds
between Shortest Path First (SPF)
recalculations. The default setting is 3 seconds.
Table 9-4:
OSPF Configuration Commands (continued)
Command Description