User guide

9-14 B
LACK
D
IAMOND
U
SER
G
UIDE
R
OUTING
P
ROTOCOLS
R
ESETTING AND
D
ISABLING
RIP
To return RIP settings to their defaults, or to disable RIP, use the commands listed in
Table 9-3.
C
ONFIGURING
OSPF
Table 9-4 describes the commands used to configure OSPF.
Table 9-3:
RIP Reset and Disable Commands
Command Description
config rip delete [vlan <name> | all] Disables RIP on an IP interface. When RIP is
disabled on the interface, the parameters are not
reset to their defaults.
disable rip Disables RIP.
disable rip aggregation Disables the RIP aggregation of subnet
information on a RIP v2 interface.
disable rip splithorizon Disables split horizon.
disable rip poisonreverse Disables poison reverse.
disable rip triggerupdate Disables triggered updates.
disable rip export static Disables the filtering of static routes.
disable rip export osfp Disables the distribution of OSPF routes into the
RIP domain.
unconfig rip {vlan <name> | all} Resets all RIP parameters to the default VLAN.
Does not change the enable/disable state of the
RIP settings.
Table 9-4:
OSPF Configuration Commands
Command Description
create ospf area <areaid> Creates an OSPF area. By default, the OSPF
area 0.0.0.0 is created.
enable ospf Enables OSPF process for the router.
enable ospf export static type [1 | 2] Exports statically configured routes to other
OSPF routers. The default setting is enabled.