User guide

B
LACK
D
IAMOND
U
SER
G
UIDE
8-15
IP C
OMMANDS
Table 8-4 describes the commands used to configure the ICMP protocol.
config iproute add default <gateway>
{<metric>}
Adds a default gateway to the routing table. A
default gateway must be located on a
configured IP interface. If no metric is
specified, the default metric of 1 is used.
config iproute delete default <gateway> Deletes a default gateway from the routing
table.
disable iproute sharing Disables load sharing for multiple routes.
Table 8-4:
ICMP Configuration Commands
Command Description
enable icmp redirects {vlan <name> | all} Enables generation of ICMP redirect messages
on one or more VLANs. The default setting is
enabled.
enable icmp unreachables {vlan <name> | all} Enables the generation of ICMP unreachable
messages on one or more VLANs. The default
setting is enabled.
enable icmp useredirects Enables the modification of route table
information when an ICMP redirect message is
received. The default setting is disabled.
enable irdp {vlan <name> | all} Enables the generation of ICMP router
advertisement messages on one or more
VLANs. The default setting is enabled.
config irdp [multicast | broadcast] Configures the destination address of the
router advertisement messages. The default
setting is multicast.
Table 8-3:
Route Table Configuration Commands (continued)
Command Description