Installation guide

Installing and Removing a XENPAK Module
Extreme Networks Pluggable Interface Modules Installation Guide
29
Removing a XENPAK Module
To remove a XENPAK module:
1 Disconnect the optical cable from the XENPAK module.
WARNING!
XENPAK modules contain Class 1 lasers. Invisible laser radiation can occur when laser connections are unplugged.
Do not stare into the beam.
2 Loosen the two captive screws until they are completely free from the I/O module faceplate or the
Summit option card. (The captive screws remain attached to the XENPAK module.)
3 Gripping both captive screws, carefully pull the XENPAK module out of the slot.
4 Place the dust covers back into the XENPAK module connectors.
5 Place the XENPAK module immediately into an antistatic container to protect it from ESD damage
and dust.