Installation Guide
Table Of Contents
- Table of Contents
- Preface
- 1: AP460i/e Overview
- 2: Install the Access Point
- AP460i/e Box Contents
- Access Point Mounting Options, Brackets, and Accessories
- Position the Access Point before Installation
- Install the Access Point on a Wall or Flat Surface
- Install the Access Point to a Flat Surface Using KT-147407-02 Flat Part and 1-Axis Tilt Part
- Install the Access Point to a Flat Surface Using the KT-147407-02 Flat Part, 1-axis Tilt Part, and the KT- 150173-01 Extension Arm
- Install the Access Point On a Flat Surface Using the KT-150173-01 Extension Arm
- Install the Access Point on a Flat Surface Using the MBO-ART02 Articulating Mounting Bracket
- Install the Access Point on a Flat Surface Using the WS-MBV-VMM Vehicle Bracket (#32216)
- Install the Access Point on a Pole
- Attaching the access point to a pole using all three KT-147407-02 bracket parts
- Attaching the access point to a pole using the pole part of the KT-147407-02 bracket
- Mounting the access point to a pole using pole part of the KT-147407-02 bracket and the KT-150173-01 extension arm
- Mounting the access point to a pole using the KT-147407-02 bracket parts and the KT-150173-01 extension arm
- Attaching the access point to a pole using the WS-MBO-POLE01 bracket and MBO-ART02 articulating mounting bracket
- 3: Powering method
- 4: GE/Console connections
- 5: Antenna configuration for external antenna model
- 6: Specifications
- 7: Regulatory Information
- Professional Installation Instruction
- Safety Guidelines
- Federal Communications Commission (FCC) Notice
- Industry Canada Notice
- Detachable Antenna Usage
- Australia Notice
- Brazil Anatel Statement
- Hazardous Substances
- Supplement to Product Instructions
- NCC Statement
- CE Information
- European Waste Electrical and Electronic Equipment (WEEE) Notice
- Declaration of Conformity in Languages of the European Community
- Index
4 Plug the RJ45 cable into the port.
Caution
Do not run the network cable through the cable conduit connector used for connecting
the power cables. You must connect the network cable and power cables through
separate connectors.
5 Slide the seal and the claw into the main body.
6 Secure the seal nut onto the main body.
7 Tighten the adapter assembly by hand. Tighten the cap to 5 inch lbs.
Note
There should still be some visible threads after you torque in the cap.
GE/Console connections
ExtremeMobility AP460i/e Outdoor Access Points 33