Installation Guide
Table Of Contents
- Table of Contents
- Preface
- 1: AP460i/e Overview
- 2: Install the Access Point
- AP460i/e Box Contents
- Access Point Mounting Options, Brackets, and Accessories
- Position the Access Point before Installation
- Install the Access Point on a Wall or Flat Surface
- Install the Access Point to a Flat Surface Using KT-147407-02 Flat Part and 1-Axis Tilt Part
- Install the Access Point to a Flat Surface Using the KT-147407-02 Flat Part, 1-axis Tilt Part, and the KT- 150173-01 Extension Arm
- Install the Access Point On a Flat Surface Using the KT-150173-01 Extension Arm
- Install the Access Point on a Flat Surface Using the MBO-ART02 Articulating Mounting Bracket
- Install the Access Point on a Flat Surface Using the WS-MBV-VMM Vehicle Bracket (#32216)
- Install the Access Point on a Pole
- Attaching the access point to a pole using all three KT-147407-02 bracket parts
- Attaching the access point to a pole using the pole part of the KT-147407-02 bracket
- Mounting the access point to a pole using pole part of the KT-147407-02 bracket and the KT-150173-01 extension arm
- Mounting the access point to a pole using the KT-147407-02 bracket parts and the KT-150173-01 extension arm
- Attaching the access point to a pole using the WS-MBO-POLE01 bracket and MBO-ART02 articulating mounting bracket
- 3: Powering method
- 4: GE/Console connections
- 5: Antenna configuration for external antenna model
- 6: Specifications
- 7: Regulatory Information
- Professional Installation Instruction
- Safety Guidelines
- Federal Communications Commission (FCC) Notice
- Industry Canada Notice
- Detachable Antenna Usage
- Australia Notice
- Brazil Anatel Statement
- Hazardous Substances
- Supplement to Product Instructions
- NCC Statement
- CE Information
- European Waste Electrical and Electronic Equipment (WEEE) Notice
- Declaration of Conformity in Languages of the European Community
- Index
6 Attach the pole bracket to a pole by positioning the cable clamps around a pole.
7 Insert the ends of the cable clamps around the pole and tighten the clamp screws to a torque of 11
in-lbs.
Attaching the access point to a pole using the WS-MBO-POLE01 bracket and
MBO-ART02 articulating mounting bracket
The following hardware is required to install the access point to a pole using the WS-MBO-POLE01
bracket and the MBO-ART02 bracket.
•
WS-MBO-POLE01 bracket
•
MBO-ART02 bracket
•
Two M6 hex-head screws
•
Four M3 screws, nuts, and washers to attach the WS-MBO-POLE01 bracket to the MBO-ART02
articulating mounting bracket
•
Two cable clamps
Note
You need to provide your own stainless-steel cable clamps. The band must be 1/2” (12.7
mm) wide.
•
Access point
To mount the access point on to a pole using WS-MBO-POLE01 bracket and the MBO-ART02
articulating mounting bracket:
1 Attach the MBO-ART02 articulating mounting bracket to the access point using two M6 hex-head
screws.
Install the Access Point
ExtremeMobility AP460i/e Outdoor Access Points 27