Installation Guide

Label Description
A Semi-circular cuts on the pole part of the
KT-147407-02 bracket, used for attaching the M6 hex-
head screws.
2 Insert the 0.5" stainless-steel cable clamp through the long slots on the sides of pole bracket.
3 Attach the pole bracket to a pole by positioning the cable clamps on the pole bracket around a pole.
4 Insert the ends of the cable clamps around the pole and tighten the clamp screws to a torque of 11
in-lbs.
Mounting the access point to a pole using pole part of the KT-147407-02
bracket and the KT-150173-01 extension arm
The access point can be mounted on to a pole using the pole part of the KT-147407-02 bracket and the
KT-150173-01 extension arm.
The following hardware is required:
•
Pole part of the KT-147407-02 bracket
•
KT-150173-01 extension arm
•
Four M6 hex-head screws
•
Two M12 stainless-steel screws and nuts
•
Two 0.5" stainless-steel cable clamps
•
Access point
To install the access point on to a pole:
1 Attach one end of the KT-150173-01 extension arm to the access point using two M6 hex-head
screws.
2 Attach the pole part of the KT-147407-02 bracket to the other end of the KT-150173-01 bracket using
two hex-head M12 stainless-steel screws and two hex-head M12 stainless-steel nuts.
3 Attach the pole bracket to a pole.
Mounting the access point to a pole using the KT-147407-02 bracket parts and
the KT-150173-01 extension arm
You can attach the access point to a pole using all the parts of the KT-147407-02 bracket and the
KT-150173-01 extension arm.
The following hardware is required:
•
Flat part of the KT-147407-02 bracket
•
1-axis tilt part of the KT-147407-02 bracket
•
Pole part of the KT-147407-02 bracket
•
KT-150173-01 extension arm
•
Six M6 hex-head screws
•
Four hex-head M12 stainless-steel screws and nuts
Install the Access Point
ExtremeMobility AP460i/e Outdoor Access Points 25