Installation Guide
Table Of Contents
- Table of Contents
- Preface
- 1: AP460i/e Overview
- 2: Install the Access Point
- AP460i/e Box Contents
- Access Point Mounting Options, Brackets, and Accessories
- Position the Access Point before Installation
- Install the Access Point on a Wall or Flat Surface
- Install the Access Point to a Flat Surface Using KT-147407-02 Flat Part and 1-Axis Tilt Part
- Install the Access Point to a Flat Surface Using the KT-147407-02 Flat Part, 1-axis Tilt Part, and the KT- 150173-01 Extension Arm
- Install the Access Point On a Flat Surface Using the KT-150173-01 Extension Arm
- Install the Access Point on a Flat Surface Using the MBO-ART02 Articulating Mounting Bracket
- Install the Access Point on a Flat Surface Using the WS-MBV-VMM Vehicle Bracket (#32216)
- Install the Access Point on a Pole
- Attaching the access point to a pole using all three KT-147407-02 bracket parts
- Attaching the access point to a pole using the pole part of the KT-147407-02 bracket
- Mounting the access point to a pole using pole part of the KT-147407-02 bracket and the KT-150173-01 extension arm
- Mounting the access point to a pole using the KT-147407-02 bracket parts and the KT-150173-01 extension arm
- Attaching the access point to a pole using the WS-MBO-POLE01 bracket and MBO-ART02 articulating mounting bracket
- 3: Powering method
- 4: GE/Console connections
- 5: Antenna configuration for external antenna model
- 6: Specifications
- 7: Regulatory Information
- Professional Installation Instruction
- Safety Guidelines
- Federal Communications Commission (FCC) Notice
- Industry Canada Notice
- Detachable Antenna Usage
- Australia Notice
- Brazil Anatel Statement
- Hazardous Substances
- Supplement to Product Instructions
- NCC Statement
- CE Information
- European Waste Electrical and Electronic Equipment (WEEE) Notice
- Declaration of Conformity in Languages of the European Community
- Index
Label Description
A Long slots on the sides of the pole part of the
KT-1474017-02 bracket. These slots are used to insert
the 0.5" stainless-steel cable clamps.
5 Attach the pole bracket to a pole by positioning the cable clamps on the pole bracket around a pole.
6 Insert the ends of the cable clamps around the pole and tighten the clamp screws to a torque of 11
in-lbs.
Attaching the access point to a pole using the pole part of the KT-147407-02
bracket
If the 1-axis tilt is not required, you can attach the pole part of the KT-147407-02 bracket to the access
point.
The following hardware is required:
•
Pole part of the KT-147407-02 access point
•
Two 0.5" wide stainless-steel cable clamps
•
Access point
•
Four M6 hex-head screws
To mount the access point on to a pole using only the pole part of the KT-147407-02 bracket:
1 Attach the pole part of the KT-147407-02 bracket to the access point using four M6 hex-head
screws.
Use the semi-circular cuts on the pole part of the KT-147407-02 bracket to attach the screws.
Figure 14: Semi circular cuts on the pole part of the KT-147407-02 bracket
Install the Access Point
ExtremeMobility AP460i/e Outdoor Access Points 24