Installation Guide
Table Of Contents
- Table of Contents
- Preface
- 1: AP460i/e Overview
- 2: Install the Access Point
- AP460i/e Box Contents
- Access Point Mounting Options, Brackets, and Accessories
- Position the Access Point before Installation
- Install the Access Point on a Wall or Flat Surface
- Install the Access Point to a Flat Surface Using KT-147407-02 Flat Part and 1-Axis Tilt Part
- Install the Access Point to a Flat Surface Using the KT-147407-02 Flat Part, 1-axis Tilt Part, and the KT- 150173-01 Extension Arm
- Install the Access Point On a Flat Surface Using the KT-150173-01 Extension Arm
- Install the Access Point on a Flat Surface Using the MBO-ART02 Articulating Mounting Bracket
- Install the Access Point on a Flat Surface Using the WS-MBV-VMM Vehicle Bracket (#32216)
- Install the Access Point on a Pole
- Attaching the access point to a pole using all three KT-147407-02 bracket parts
- Attaching the access point to a pole using the pole part of the KT-147407-02 bracket
- Mounting the access point to a pole using pole part of the KT-147407-02 bracket and the KT-150173-01 extension arm
- Mounting the access point to a pole using the KT-147407-02 bracket parts and the KT-150173-01 extension arm
- Attaching the access point to a pole using the WS-MBO-POLE01 bracket and MBO-ART02 articulating mounting bracket
- 3: Powering method
- 4: GE/Console connections
- 5: Antenna configuration for external antenna model
- 6: Specifications
- 7: Regulatory Information
- Professional Installation Instruction
- Safety Guidelines
- Federal Communications Commission (FCC) Notice
- Industry Canada Notice
- Detachable Antenna Usage
- Australia Notice
- Brazil Anatel Statement
- Hazardous Substances
- Supplement to Product Instructions
- NCC Statement
- CE Information
- European Waste Electrical and Electronic Equipment (WEEE) Notice
- Declaration of Conformity in Languages of the European Community
- Index
3 Align the large holes and assemble both the stiener plates inside the AP attach assembly plate.
Figure 9: VMM access point attach assembly plate stiener #1 and stiener #2
4 Attach four M4 or M6 screws to stiener plate #2 and align the AP's threaded holes to the AP attach
assembly plate.
The screw head goes inside the small bracket with the bent sides.
Note
The bracket comes with four M4 screws.
5 Tighten the screws to 10 in-lbs.
6 Align the AP attach assembly plate to the vehicle attach assembly plate and tighten using four
thumbscrews.
Note
The access point will not be centered and some of the attachment holes in the access
point attach assembly plate will be visible.
Install the Access Point on a Pole
You can install the access point on a pole using the following mounting brackets:
•
KT-147407-02 bracket parts
•
KT-147407-02 pole part
Install the Access Point
ExtremeMobility AP460i/e Outdoor Access Points 20