Installation Guide
Table Of Contents
- Table of Contents
- Preface
- 1: AP460i/e Overview
- 2: Install the Access Point
- AP460i/e Box Contents
- Access Point Mounting Options, Brackets, and Accessories
- Position the Access Point before Installation
- Install the Access Point on a Wall or Flat Surface
- Install the Access Point to a Flat Surface Using KT-147407-02 Flat Part and 1-Axis Tilt Part
- Install the Access Point to a Flat Surface Using the KT-147407-02 Flat Part, 1-axis Tilt Part, and the KT- 150173-01 Extension Arm
- Install the Access Point On a Flat Surface Using the KT-150173-01 Extension Arm
- Install the Access Point on a Flat Surface Using the MBO-ART02 Articulating Mounting Bracket
- Install the Access Point on a Flat Surface Using the WS-MBV-VMM Vehicle Bracket (#32216)
- Install the Access Point on a Pole
- Attaching the access point to a pole using all three KT-147407-02 bracket parts
- Attaching the access point to a pole using the pole part of the KT-147407-02 bracket
- Mounting the access point to a pole using pole part of the KT-147407-02 bracket and the KT-150173-01 extension arm
- Mounting the access point to a pole using the KT-147407-02 bracket parts and the KT-150173-01 extension arm
- Attaching the access point to a pole using the WS-MBO-POLE01 bracket and MBO-ART02 articulating mounting bracket
- 3: Powering method
- 4: GE/Console connections
- 5: Antenna configuration for external antenna model
- 6: Specifications
- 7: Regulatory Information
- Professional Installation Instruction
- Safety Guidelines
- Federal Communications Commission (FCC) Notice
- Industry Canada Notice
- Detachable Antenna Usage
- Australia Notice
- Brazil Anatel Statement
- Hazardous Substances
- Supplement to Product Instructions
- NCC Statement
- CE Information
- European Waste Electrical and Electronic Equipment (WEEE) Notice
- Declaration of Conformity in Languages of the European Community
- Index
•
Stiener plate #2; used with the AP attach assembly plate
•
Vehicle attach assembly plate with PEMS
Table 8: WS-MBV-VMM Vehicle Bracket (#32216) box contents
Item Quantity
VMM vehicle attach assembly Vehicle attach plate with PEMS
VMM AP attach assembly AP attach flat plate with stiener #1 and stiener #2
Philips Pan Head M4 (15mm) screws Four screws to attach the AP attach assembly plate to
the access point
The installer must provide the following hardware:
Access point The access point that you are using for installation
Screws or bolts to attach the vehicle attach assembly
plate
Four screws or bolts required
Torque wrench/screwdriver Required to attach the screws/bolts and assembly
plates
1 Using the vehicle assembly plate long inner X slots as a template, mark and drill the attachment
holes on a flat surface.
Figure 8: VMM vehicle attach assembly plate
2 Attach the vehicle attach assembly plate using four screws or bolts.
The screws or bolts must be tightened suciently to hold the bracket and the access point in all
environmental conditions.
Install the Access Point
ExtremeMobility AP460i/e Outdoor Access Points 19