Installation Guide

Figure 6: KT-150173-01 extension arm
The following hardware is required for installation:
•
KT-147407-02 flat part
•
KT-147407-02 1-axis tilt part
•
KT-150173-01 extension arm
•
Access point
•
Ten M6 hex-head screws
•
Two M6 hex-head screws to attach the KT-147407-02 flat part to the access point
•
Four M6 hex-head screws to attach the 1-axis tilt part to the flat bracket
•
Four M6 hex-head screws to attach the KT-150173-01 extension arm to a flat surface
•
Two hex-head M12 stainless-steel screws and nuts
1 Attach the KT-147407-02 flat part to the access point using two M6 screws.
2 Place the KT-147407-02 flat part inside the 1-axis tilt part, and attach it using four M6 screws.
3 Using the KT-150173-01 extension arm as a template, mark four hole centers on a flat surface.
The holes must be within the semi-circular cuts of the extension arm.
4 Attach one end of the KT-150173-01 extension arm to the 1-axis tilt part using two hex-head M12
stainless-steel screws and two hex-head M12 stainless-steel nuts through the two large circular holes
on the KT-150173- 01 extension arm.
5 Attach the KT-150173-01 extension arm to a flat surface using four M6 size hex-head screws.
Use screw-in anchors with the four M6 size hex-head screws on wood surface.
To mount the extension arm on a concrete surface, use concrete anchors.
Install the Access Point
ExtremeMobility AP460i/e Outdoor Access Points 16