Installation Guide

Table 7: AP460i/e mounting brackets and accessories usage
Mounting bracket and part
number
Wall install Pole install Notes
KT-147407-02; bracket;
comes with three parts:
•
Flat part
•
1-axis tilt part
•
Pole part
Yes Yes For attaching to a wall or a
flat surface, use the
bracket part that has two
holes on the surface of the
metal portion; also called
the flat part. For attaching
to a pole, if the 1-axis tilt is
not required, attach the
pole part of the bracket to
the access point. If 1-axis
tilt is required, attach the
pole part of the
KT-147407-02 bracket on
top of the second wall part.
KT-150173-01; extension
arm; used with
KT-147407-02 bracket
parts
Yes; use the flat wall mount
part of the KT-147407-02
bracket
Yes; use the pole mount
bracket part of the
KT-147407-02 bracket or
use all three KT-147407-02
bracket parts
The KT-150173-01 extension
arm can also be used by
itself without the other
KT-147407-02 bracket
parts.
MBO-ART02; 10" 2-Axis
articulating mounting
bracket
Yes Yes; attach the MBO-
ART02 articulating
mounting bracket to the
WS-MBO-POLE01 bracket
The wall must be strong
enough to support the AP
during inclement weather.
WS-MBO-POLE01 bracket No Yes; the POLE01 bracket
can only be used with the
MBO-ART02 articulating
mounting bracket
If the pole diameter is <= 1"
(25.4mm), use small cable
clamp. If the pole diameter
is between 5" - 7" (178mm),
use large cable clamp. For
any other pole diameter,
provide your own stainless
steel cable clamp. The
band must be 1/2”
(12.7mm) wide.
WS-MBV-VMM Vehicle
Bracket (#32216); comes
with fours parts
Yes No None
Note
All brackets and accessories are sold separately.
Install the Access Point
ExtremeMobility AP460i/e Outdoor Access Points 13