Installation guide

Chapter 3: Initial Access Point Configuration
Altitude™ 4760 Series Access Point Installation Guide
40
ap4760-XXXXXX (config-device-xx-xx-xx-xx-xx-xx-if-radio1)#service antenna-
type ap4760 Series-dipole
Select antenna gain with following command:
ap4760-XXXXXX (config-device-xx-xx-xx-xx-xx-xx-if-radio1)# antenna-gain
<units in dBi>
These changes can also be made in the device profile configuration file.
NOTE
For FCC and ETSI requirements, set the 2.4GHz radio gain to 8 dBi and set the 5GHz radio
gain to 10 dBi.
Automatic Channel Select Override
Under certain conditions (e.g. the presence of a 40 MHz channel intolerant client or a legacy
device on the extension channel), a radio which has been configured for 40 MHz channel
operation may automatically select the 20 MHz channel. To override or restore automatic
channel selection, use the following commands:
ap4760-XXXXXX (config-device-xx-xx-xx-xx-xx-xx-if-radio1)#service
ignore-ch-width-mgmt
ap4760-XXXXXX (config-device-xx-xx-xx-xx-xx-xx-if-radio1)#no service
ignore-ch-width-mgmt
This change can also be made in the device profile configuration file.