Installation guide
Altitude™ 4760 Series Access Point Installation Guide
39
CHAPTER
3
Initial Access Point
Configuration
The Altitude 4760 Series Access Point receives its configuration once it is adopted by an
Extreme Networks Summit
®
WM3000 Series controller. There are no required initial
configuration settings beyond verifying power and LED functionality for the Access Point.
Once adopted, the Access Point is managed by its connected controller and can receive
periodic firmware updates when Extreme Networks releases updates with new controller
functionality.
For information on how use an Extreme Networks Summit WM3000 Series controller to
manage an Altitude 4760 Series Access Point, refer to
http://www.extremenetworks.com/go/
documentation
.
NOTE
An Altitude 4760 Series Access Point can operate as a dependent AP when configured or
managed by an Extreme Networks Summit WM3000 Series controller or as an independent AP. Check
applicable software release notes and system reference guides to determine if independent mode
operation is supported by a particular software version.
Antenna Type Configuration
For the Altitude 4760 Series Access Point to operate properly, the antenna type and antenna
gain must be configured manually.
Select antenna type with the following command: